System-sensor 6424 Projected Beam Type Manuale Utente

D400-18-00 1 I56-494-13RPRINTED IN MEXICO6424 Projected Beam Type Smoke DetectorINSTALLATION AND MAINTENANCE INSTRUCTIONS 3825 Ohio Avenue, St. C

indicate alignment mode, but the trouble relay will not activate. If the receiver is left in the alignment mode for more than an

NOTE: Before testing the detector, check for the presence of the flashing green LED at the receiver, making sure not to disturb or block the beam

D400-18-00 12 I56-494-13R ©2004 System Sensor PRINTED IN MEXICOThree-Year Limited WarrantySystem Sensor warrants its enclosed smoke dete

Before InstallingPlease thoroughly read this manual and applicable sections of System Sensor’s Projected Beam Detector Application Guide. Copie

In a room with a smooth ceiling, detectors should be spaced between 30 and 60 feet. One-half that spacing between the beam and the sidewall may be use

Mounting BracketsInstall a ceiling or wall bracket for both the receiver and transmitter so that when mounted, the receiver and the t

CLASS ARETURN LOOPINITIATINGLOOPPOWERTODETECTORSLISTED PANELTRANSMITTERBLUE GREENORANGEGREENBLACKRED-WHITESTRIPEWHITEWHITE-BLACKSTRIPEGRAYVIOLETWHITE-

aid. If the remote power configuration is used, the remote power source must comply with all codes and directives of the Authority Having Juri

Figure 12. Wall mounting:HORIZONTAL ADJUSTMENT SCREW(#10-24 x 1-3/8 in.)METAL WASHERMOUNTING HUBMOUNTING HUBALIGNMENTLEDsSTATUSLEDs(RECEIVER ONLY)BEAM

Figure 14. Rear view receiver:ACCESS DOORCONNECTOR16 CONDUCTORCABLERESET SWITCH3055SENSITIVITYSELECT SWITCHNAALIGNMENTMODE SWITCHC0548-00Figure 15.

4 RED LEDs USEDFOR ALIGNMENTGREEN: FLASHES APPROXIMATELY EVERY2 SECONDS IF POWERED UP ANDSENSING A SAFE CONDITION.YELLOW: TURNS ON WHILE A TROUBLECON